Your oven will stay locked and a fan will run until it cools. The high heat reduces stuck-on food and grease to ash in a process called pyrolytic cleaning. Next, your oven will lock and heat up to a very high temperature. For service, please schedule an appointment with GE Appliances Factory Service. In order for the self-cleaning cycle to start, the door must be closed. If the above does not correct the situation, service may be required. Hit the Clear/Off or Cancel button immediately. The control should now be reset and there should not be a need for service. Wait 10 seconds for the display to clear.

When the Self Clean cycle initiates, press the Clear/Off or Cancel pad immediately to cancel it. Press the Self Clean pad and wait 10 seconds. While you hold the door jamb switch in this position, complete the following steps. Push it in until the oven cavity light goes off, indicating that the oven believes the door is closed. It will look like a small black post or dowel. With the door open, locate the door jamb switch on the face of the oven.

If this does not appear to be the result of setting the Control Lockout feature, follow the steps below to reset your control: Consult your Owner's Manual for directions specific to your model. If a “LOC DOOR” message is flashing in the display of your range or wall oven and the self-clean cycle has not been selected, please check to make sure the Control Lockout feature was not engaged. Failure to take this precaution could result in tipping of the range and injury. Please refer to the Anti-Tip device information in this manual. If it is not, there is a possible risk of the range tipping over and causing injury if you or a child stand, sit or lean on an open door. Range & Wall Oven - “LOC DOOR” Flashes in the Display engaged when you push the range back against the wall.

Hotpoint stove manual self cleaning